EDS94ARNExxxx EN 2.3 - 06/2014 L 57
9400 regenerative power supply module | Parameter setting
Device interface
Device commands
4.1.17 Reset error
The C00002
= "43: Reset error" device command is used to acknowledge an existing error
message, provided that the error cause is eliminated and thus no error is pending.
Tip!
An error message can also be acknowledged by clicking the Reset error button on
the Diagnostics tab.
Further information on error messages can be found in the chapter "Diagnostics &
fault analysis". ( 187)
Note!
This device command has no status display in C00003, i.e. the display remains
unchanged showing the previous device command status.
To Next Page
Loading...
