9400 regenerative power supply module | Parameter setting
Device interface
Device commands
48 L EDS94ARNExxxx EN 2.3 - 06/2014
4.1.9 Start application
The C00002
= "31: Start application" device command serves to start the active application
in the regenerative power supply module.
[4-6] "Start application" function
The number of the currently active application is displayed in C00007.
The current program state is displayed in C02108
.
Tip!
This device command can also be activated via the icon in the Toolbar.
Possible status displays for this device command
Related device commands
Stop application
( 49)
Memory module MM
9400
RAM
Firmware Application 1Application
Application 2
Application 3
Status (C00003) Meaning
2065666 Device command in process
2031616 Device command executed successfully
2031617 General fault
To Next Page
Loading...
