9400 regenerative power supply module | Parameter setting
Device interface
Device commands
78 L EDS94ARNExxxx EN 2.3 - 06/2014
4.1.36 Restart controller
The device command C00002
= "11000: Restart controller" serves to restart the
regenerative power supply module by parameter setting.
Only possible when the controller is inhibited and the application has been stopped.
Possible status displays for this device command
Status (C00003) Meaning
720930050 Device command in process
720896001 General fault
Note!
Because of the restart in the case of a successful execution of the device
command, this status will not be displayed in
C00003.
If this device command is used, the "Undervoltage in DC bus (0x007b000f)"
message may appear in the logbook.
To Next Page
Loading...
