9400 regenerative power supply module | Parameter setting
Device interface
Device commands
52 L EDS94ARNExxxx EN 2.3 - 06/2014
4.1.13 Restart program
The C00002
= "35: Restart program" device command serves to restart the application
program in the regenerative power supply module.
All variables except for the RETAIN variables are reset to their initialisation values.
The situation corresponds to a power failure or a switching off and on again of the
regenerative power supply module (warm start) while the program is running.
Possible status displays for this device command
Related device commands
Reset program
( 50)
Delete program
( 51)
Status (C00003) Meaning
2327810 Device command in process
2293760 Device command executed successfully
2293761 General fault
To Next Page
Loading...
Need help?
General
