EDS94ARNExxxx EN 2.3 - 06/2014 L 15
9400 regenerative power supply module | Parameter setting
Commissioning
Short setup
2.1.3 Commissioning with the Engineer
For commissioning with the Lenze PC software »Engineer« you need:
A PC with the following system requirements:
– Processor with at least 1.4 GHz
– At least 512 MB RAM and 650 MB of free hard disk space
– Operating system Microsoft® Windows® 2000 (service pack 2 or higher) or
Windows® XP
A connection to the regenerative power supply module, e. g. via the diagnostic adapter
offered by Lenze.
Tip!
An online connection can also be established via optional interfaces which are
provided by corresponding communication modules in the module receptacles
MXI1/MXI2 of the regenerative power supply module.
Detailed information about the different interfaces can be found in the
corresponding Communication Manuals.
Note!
Please observe the documentation for the diagnostic adapter!
For communication with the regenerative power supply module, at least the
control electronics of the regenerative power supply module must be supplied
with 24-V low voltage via the connector X2; detailed information on this can be
found in the Mounting Instructions for the regenerative power supply module.
Stop!
If you alter parameters in the »Engineer« while an online connection to the
regenerative power supply module is established, the changes are directly
accepted in the regenerative power supply module!
To Next Page
Loading...
Need help?
General
