Lenze L-force 9400 Series Software Manual

EDS94ARNExxxx EN 2.3 - 06/2014 L 209
9400 regenerative power supply module | Parameter setting
Diagnostics & fault analysis
Error messages
8.6.4 Cause & possible remedies
This chapter contains all error messages of the device operating system in numerical order
of the error number with detailed information on the response to the error message and
information on the cause & possible remedies.
 Tip!
A list of all error messages of the device operating system in alphabetical order can
be found in the previous chapter "Short overview (A-Z)
". ( 203)
Logbook: Overflow [0x00650000]
Logbook: Reset (read error) [0x00650001]
Logbook: Reset (version error) [0x00650002]
Memory module is missing [0x00650003]
Control card is defect [0x00680000]
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Too many events/errors have occurred in a very short
time. It was therefore not possible to list all of them in
the logbook.
Check whether application generates too many error
messages.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The logbook has been reset due to a read error. - (Is irreversible)
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
The logbook has been reset due to a version conflict. - (Is irreversible)
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Memory module is defective or not available. Use a different memory module.
Response (Lenze setting printed in bold)
 None  System fault  Fault  Trouble  Quick stop by trouble  Warning locked  Warning  Information
Cause Remedy
Operating system could not identify the control card. Mains switching
• Please contact Lenze if the error occurs again.

Lenze L-force 9400 Series Specifications

General

Brand	Lenze
Model	L-force 9400 Series
Category	Servo Drives
Language	English