Lenze L-force 9400 Series - Page 323

EDS94ARNExxxx EN 2.3 - 06/2014 L 323
9400 regenerative power supply module | Parameter setting
Parameter reference
Parameter list | C00780
C00780
C00783
C00784
C00786
C00789
C00854
Parameter | Name:
C00780 | ECTRL_dnIfilterAct
Data type: INTEGER_32
Index: 23795
d
= 5CF3
h
Internal signal of the control system
Display range (min. value | unit | max. value)
-500.00 A 500.00
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100
Parameter | Name:
C00783 | ECTRL_dwLineVoltageAct
Data type: UNSIGNED_32
Index: 23792
d
= 5CF0
h
Internal signal of the control system
Display range (min. value | unit | max. value)
0 V 2000
 Read access  Write access  CINH  PLC STOP  No transfer
Parameter | Name:
C00784 | ECTRL_dnLineFreqAct
Data type: INTEGER_32
Index: 23791
d
= 5CEF
h
Internal signal of the control system
Display range (min. value | unit | max. value)
-800.0 Hz 800.0
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 10
Parameter | Name:
C00786 | ECTRL_dnIxtLoad
Data type: INTEGER_32
Index: 23789
d
= 5CED
h
Internal signal of the control system
Display range (min. value | unit | max. value)
-200.00 % 200.00
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100
Parameter | Name:
C00789 | ECTRL_dwMaxDeviceCurrent
Data type: INTEGER_32
Index: 23786
d
= 5CEA
h
Internal signal of the control system
Display range (min. value | unit | max. value)
0.00 A 21474836.47
 Read access  Write access  CINH  PLC STOP  No transfer Scaling factor: 100
Parameter | Name:
C00854 | Service code
Data type: UNSIGNED_32
Index: 23721
d
= 5CA9
h
This code is used internally by the device and must not be overwritten by the user!