Lenze L-force 9400 Series

To Next Page

To Previous Page

EDS94ARNExxxx EN 2.3 - 06/2014 L 329

9400 regenerative power supply module | Parameter setting

Parameter reference

Parameter list | C01215

C01215

C01217

C01220

C01221

C01222

C01223

Parameter | Name:

C01215 | Set time and date

Data type: UNSIGNED_16

Index: 23360

= 5B40

Setting of the device's system time displayed in C01214.

• If the MM440 memory module with real-time clock is plugged into the regenerative power supply module, the

real-time clock is set simultaneously.

Set time and date.

• Before writing to a subcode for the first time, the current time of the internal clock is displayed in the subcodes.

• When a subcode has been overwritten, the display in the subcodes freezes to the last values.

• The reset system time is only accepted after each subcode has been overwritten at least once.

• After the new system time has been accepted, the display in the subcodes is updated according to the internal

clock.

Note:

If a memory module without real-time clock is plugged into the regenerative power supply module, the internal

clock is initialised with "01.01.1970 00:00:00" every time the power is switched on.

Setting range (min. value | unit | max. value)

0 65535

Subcodes Lenze setting Information

C01215/1 0 Seconds

C01215/2 0 Minutes

C01215/3 0 Hours

C01215/4 0 Day

C01215/5 0 Month

C01215/6 0 Year

 Read access  Write access  CINH  PLC STOP  No transfer

Parameter | Name:

C01217 | Service code

Data type: VISIBLE_STRING

Index: 23358

= 5B3E