2-1. Instrument cluster
Shift position and shift range/gear position
Displays the selected shift position or selected shift range/gear position (oP.233)
Multi-information display
Presents the driver with a variety of driving-related data (oP.124)
Displays warning messages if a malfunction occurs (oP.592)
Odometer, trip meter and oil maintenance
Odometer:
Displays the total distance that the vehicle has been driven
Trip meter:
Displays the distance the vehicle has been driven since the meter was last reset. Trip
meters “A” and “B” can be used to record and display different distances independently.
Oil maintenance:
Displays the distance until the next engine oil change.
Engine coolant temperature gauge
Displays the engine coolant temperature
Q Outside temperature display
O In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change.
• When stopped, or driving at low speeds
(less than 20 km/h [12 mph])
• When the outside temperature has
changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
O When “--” or “E” is displayed, the system
may be malfunctioning.
Take your vehicle to your Lexus dealer.
O Displays the outside temperature within
the range of -40°C (-40°F) to 60°C
(140°F).
O When the outside temperature is
approximately 3°C (37°F) or lower, the
indicator will flash for approximately
10 seconds, then stay on.
Q Liquid crystal display
oP.125
I
J
K
L
Q The information display at low tem-
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low tem-
peratures, the display monitor may
respond slowly, and display changes may
be delayed.
For example, there is a lag between the
driver’s shifting and the new gear num-
ber appearing on the display. This lag
could cause the driver to downshift
again, causing rapid and excessive
engine braking and possibly an accident
resulting in death or injury.
Q To prevent damage to the engine and
its components
O Do not let the indicator needle of the
tachometer enter the red zone, which
indicates the maximum engine speed.
To Next Page
Loading...
