4-3. Operating the lights and wipers
tion of movement for the vehicle. This is
to ensure excellent visibility when
either driving at intersections or park-
ing at night.
z The steering wheel is operated
z The turn signal lever is operated
z The shift lever is in R (both left and
right side cornering lights)
Q Cornering light control
O The lights illuminate when the vehicle
speed is approximately 30 km/h (19
mph) or less. However, the lights turn off
when the vehicle speed increases to
approximately 35 km/h (22 mph) or
more.
O After the lights remain illuminated for 30
minutes, they automatically turn off.
*
:If equipped
z Adjusts the brightness and illumi-
nated area of the high beams
according to the vehicle speed.
z Adjusts the intensity of the high
beams, while driving on a curve, so
that the area in the direction that the
vehicle is turning will be illuminated
more brightly than other areas.
z Operates the shaded high beams so
that the area around vehicles ahead
is partially not illuminated while all
other areas continue to be illumi-
AHS (Adaptive High-beam
System)
*
The Adaptive High-beam System
uses a front camera located behind
the upper portion of the windshield
to assess the brightness of the lights
of vehicles ahead, streetlights, etc.,
and automatically controls the
headlight light distribution as nec-
essary.
Q Limitations of the Adaptive High-
beam System
Do not overly rely on the Adaptive High-
beam System. Always drive safely, taking
care to observe your surroundings and
turning the high beams on or off manu-
ally if necessary.
Q To prevent incorrect operation of the
Adaptive High-beam System
Do not overload the vehicle.
System functions
To Next Page
Loading...
