5-3. Using the air conditioning system and defogger
The driver’s side temperature control
switches can be used to adjust the tem-
perature for the driver’s and passenger’s
side. To enter individual mode, operate the
passenger’s side temperature control
switches or select the “SYNC” switch
again.
When the “SYNC” mode is on, the indica-
tor illuminates on display.
Directing airflow to the front seats only
and to all seats can be switched via
switch operation. Unnecessary air
conditioning is suppressed, contribut-
ing to increased fuel efficiency.
Select on the option control screen
of the air conditioning control screen
and switch the airflow.
(ON): Airflow to the front seats
only
(OFF): Airflow to all the seats
Even if the function is switched to directing
airflow to only the front seats, when a rear
seat is occupied, it may automatically direct
airflow to all seats.
Q Heater idle up
This feature is used to boost heating
effect in extremely cold conditions
when the vehicle is not moving.
X Left-hand drive vehicles
X Right-hand drive vehicles
Press the switch to increase engine
speed.
Press the switch again to return the engine
to the normal idle speed. If you do not turn
the switch to off, the engine speed is
increased whenever the engine is started.
Q Power heater
This feature is used to heat the engine
coolant, speed up warming of the cab
in cold weather, and keep the cab
warm.
Using front seat concentrated
airflow mode (S-FLOW)
Heater idle up (if
equipped)/Power heater (if
equipped)
To Next Page
Loading...
