Lexus LX600 2021 - RCD (Rear Camera Detection) Function

331
4
4-5. Using the driving support systems
Driving
Pedestrian detection icon
Displayed automatically when a pedestrian
is detected.
Use the meter control switches to
enable/disable the RCD function.
(oP.125)
1
Press the meter control switch to
select .
2
Press the meter control switch to
select “RCD” and then press .
RCD (Rear Camera Detec-
tion) function
When the vehicle is backing up, the
rear camera detection function can
detect pedestrians in the detection
area behind the vehicle. If a pedes-
trian is detected, a buzzer will
sound and an icon will be displayed
on the Multimedia Display to
inform the driver of the pedestrian.
WARNING
Q Cautions regarding the use of the
system
The recognition and control capabilities
for this system are limited.
The driver should always drive safely by
always being responsible without over
relying on the system and have a under-
standing of the surrounding situations.
Q To ensure the system can operate
properly
Observe the following, otherwise there is
the danger that could lead to an acci-
dent.
O Always clean the camera without
damaging it.
O Do not install market electronic parts
(such as Illuminated license plate, fog
lamps, etc.) in the camera vicinity.
O Do not subject the camera vicinity to
strong impacts. If the vicinity is sub-
jected to a strong impact, have the
vehicle inspected by your Lexus
dealer.
O Do not disassemble, remodel or paint
the camera.
O Do not attach accessories or stickers
to the camera.
O Do not install market protection parts
(bumper trim, etc.) to the rear bumper.
O Maintain suitable tire air pressure.
O Make sure the back door is completely
closed.
Q RCD function is turned off
In the following situations the system
turns off. The RCD function may not
operate properly and thus there is the
danger that an accident may occur.
O The contents mentioned above are not
observed.
O Suspensions other than Lexus genu-
ine parts are installed.
Multimedia Display
Turning the RCD function on/off
A