8
8-1. Specifications
Vehicle specifications
API Service Symbol
Top portion: “API SERVICE SP” means
the oil quality designation by American
Petroleum Institute (API).
Center portion: “SAE 0W-20” means the
SAE viscosity grade.
Lower portion: “Resource-Conserving”
means that the oil has fuel-saving and envi-
ronmental protection capabilities.
ILSAC Certification Mark
The International Lubricant Specification
Advisory Committee (ILSAC) Certifica-
tion Mark is displayed on the front of the
container.
X Diesel engine
Q Oil capacity (Drain and refill [Ref-
erence
*
])
*
: The engine oil capacity is a reference
quantity to be used when changing the
engine oil. Warm up and turn off the
engine, wait more than 5 minutes, and
check the oil level on the dipstick.
Q Engine oil selection (except for
EURO V and VI models
*
)
*
: EURO V and VI are emission standards.
If it is not clear that your vehicle meets
relevant standards, contact your Lexus
dealer
“Toyota Genuine Motor Oil” is used in
your Lexus vehicle. Use Lexus
approved “Toyota Genuine Motor
Oil” or equivalent to satisfy the follow-
ing grade and viscosity.
Oil grade:
API CF-4, CF or ACEA B3, B4, B5 or
JASO DL-0
Recommended viscosity (SAE):
SAE 5W-30 is the best choice for
good fuel economy and good starting
in cold weather.
If you use SAE 10W-30 or a higher
viscosity engine oil in extremely low
temperatures, the engine may become
difficult to start, so SAE 5W-30 engine
oil is recommended.
Temperature range anticipated
before next oil change
Preferred
Oil viscosity (5W-30 is explained here
as an example):
• The 5W in 5W-30 indicates the
characteristic of the oil which allows
cold startability. Oils with a lower
With filter
6.6 L (7.0 qt., 5.8
Imp.qt.)
Without filter
6.2 L (6.6 qt., 5.5
Imp.qt.)
A
B
A
B
To Next Page
Loading...
