6-3. Do-it-yourself maintenance
Check if the treadwear indicators are
showing on the tires. Also check the
tires for uneven wear, such as exces-
sive wear on one side of the tread.
Check the spare tire condition and
pressure if not rotated.
New tread
Worn tread
Treadwear indicator
The location of treadwear indicators is
shown by a “TWI” or “ ” mark, etc.,
molded into the sidewall of each tire.
Q When refilling AdBlue™
Observe the following precautions.
Failure to do so may result in damage to
the vehicle parts, paint, etc.
O Do not use urea solution other than
AdBlue™.
O If AdBlue™ comes into contact with
any painted surfaces on the vehicle,
immediately wash the affected areas
with water.
Q When refilling AdBlue™ with the
refilling equipment
Observe the following precautions to
prevent AdBlue™ overflowing from the
AdBlue™ tank:
O Securely insert the nozzle into the
AdBlue™ filler neck.
O Stop filling the tank after the nozzle
automatically clicks off.
O Do not top off the AdBlue™ tank.
Q When storing AdBlue™ containers
Observe the following precautions.
Failure to do so may result in damage to
vehicle parts, paint, etc., and changes in
the chemical compounds of AdBlue™
may cause unpleasant odors.
O Do not leave AdBlue™ containers
inside the vehicle.
O Tightly seal AdBlue™ containers and
store them in a cool, dry location with
good ventilation and no exposure to
direct sunlight.
Replace or rotate tires in accor-
dance with maintenance schedules
and treadwear.
Checking tires
A
B
C
To Next Page
Loading...
