4
4-5. Using the driving support systems
Driving
*
: If equipped
Q Meter display
Multi-information display
Set speed
Indicators
Q Operation switches
Cruise control main switch
“+RES” switch
Cancel switch
“-SET” switch
Vehicle-to-vehicle distance switch
Dynamic radar cruise con-
trol with full-speed range
*
In vehicle-to-vehicle distance con-
trol mode, the vehicle automati-
cally accelerates, decelerates and
stops to match the speed changes
of the preceding vehicle even if the
accelerator pedal is not depressed.
In constant speed control mode,
the vehicle runs at a fixed speed.
Use the dynamic radar cruise con-
trol with full-speed range on free-
ways and highways.
z Vehicle-to-vehicle distance con-
trol mode (oP.285)
z Constant speed control mode
(oP.290)
System Components
A
B
C
Q Before using dynamic radar cruise
control with full-speed range
O Driving safely is the sole responsibility
of the driver. Do not rely solely on the
system, and drive safely by always pay-
ing careful attention to your surround-
ings.
O The dynamic radar cruise control with
full-speed range provides driving
assistance to reduce the driver’s bur-
den. However, there are limitations to
the assistance provided.
Read the following conditions carefully.
Do not overly rely on this system and
always drive carefully.
• When the sensor may not be correctly
detecting the vehicle ahead: oP.292
• Conditions under which the vehicle-
to-vehicle distance control mode may
not function correctly: oP.293
A
B
C
D
E
To Next Page
Loading...
