2
2-1. Instrument cluster
Vehicle status information and indicators
map data will be displayed.
The following settings can be changed
on of the multi-information display.
(oP.124)
z Enabling/disabling the head-up dis-
play
Select to enable/disable the head-up dis-
play.
z Brightness and vertical position of
the head-up display
Select to adjust the brightness or vertical
position of the head-up display.
z Tachometer Settings
Select to display the following items:
•Blank
• Eco Driving Indicator
•Tachometer
z Display content
Select to enable/disable the following
items:
• Navigation display (if equipped)
• Driving Assist display
*
• Compass (if equipped)
• Audio system operation status
*
: Make sure to enable this display when
using the driving support systems
z Display angle
Select to adjust the angle of the head-up
display.
Q Enabling/disabling of the head-up dis-
play
If the head-up display is disabled, it will
remain disabled when the engine switch is
turned off then back to ON.
Q Display brightness
The brightness of the head-up display can
be adjusted on of the multi-information
Q When using the head-up display
O Check that the position and brightness
of the head-up display image does not
interfere with safe driving. Incorrect
adjustment of the image’s position or
brightness may obstruct the driver’s
view and lead to an accident, resulting
in death or serious injury.
O Do not continuously look at the head-
up display while driving as you may fail
to see pedestrians, objects on the
road, etc. ahead of the vehicle.
Q Head-up display projector
O Do not place any drinks near the head-
up display projector. If the projector
gets wet, electrical malfunctions may
result.
O Do not place anything on or put stick-
ers onto the head-up display projector.
Doing so could interrupt head-up dis-
play indications.
O Do not touch the inside of the head-up
display projector or thrust sharp edges
or the like into the projector.
Doing so could cause mechanical mal-
functions.
Using the head-up display
To Next Page
Loading...
