3
3-2. Opening, closing and locking the doors
Before driving
The settings of the power back door
system can be changed by displaying
the “Vehicle Settings” - screen
from of the multi-information dis-
play. (oP.124)
The changed power back door settings are
not reset by turning the engine switch to
OFF. In order to restore the original set-
tings, they need to be changed back on
of the multi-information display.
The open position of the power back
door can be adjusted.
Stop the back door in the desirable
position. (oP.149)
Press and hold the switch on
the lower part of the back door for
approximately 2 seconds.
When the settings are completed, the
buzzer sounds 4 times.
When opening the back door the next
time, the back door will stop at that posi-
tion.
Q Canceling the adjusted open position of
the back door
Press and hold the switch on the
lower part of the back door for approxi-
mately 7 seconds.
After the buzzer sounds 4 times, it sounds
twice more. When the power back door
does the opening operation the next time,
the door will open to the initial settings posi-
tion.
O Do not subject the kick sensor or its
surrounding area to a strong impact.
If the kick sensor or its surrounding
area has been subjected to a strong
impact, the kick sensor may not oper-
ate properly. If the kick sensor does
not operate in the following situations,
have the vehicle inspected by your
Lexus dealer.
• The kick sensor or its surrounding area
has been subjected to a strong impact.
• The right lower part of the rear
bumper is scratched or damaged.
O Do not disassemble the rear bumper.
O Do not attach stickers to the rear
bumper.
O Do not paint the rear bumper.
O If a bicycle carrier or similar heavy
object is attached to the power back
door, disable the kick sensor.
(oP.124)
Changing settings of the power
back door system
Adjusting the open position of
the back door
To Next Page
Loading...
