Lexus LX600 2021 - Page 203

202
3-5. Opening, closing the windows and moon roof
2
Tilts the moon roof down
*
*
: Lightly press either end of the moon roof
switch to stop the moon roof partway.
Q The moon roof can be operated when
The engine switch is in ON.
Q Operating the moon roof after turning
the engine off
The moon roof can be operated for approx-
imately 45 seconds after the engine switch
is turned to ACC or OFF. It cannot, how-
ever, be operated once either front door is
opened.
Q Jam protection function
If an object is detected between the moon
roof and the frame while the moon roof is
closing or tilting down, travel is stopped and
the moon roof opens slightly.
Q Sunshade
The sunshade can be opened and closed
manually. However, the sunshade will open
automatically when the moon roof is
opened.
Q Operating the moon roof using the
voice control system
*
*
: If equipped
The moon roof can be opened and closed
using the voice control system.
For details regarding the voice control sys-
tem, refer to the “Multimedia Owner’s
Manual”.
Q Door lock linked moon roof operation
O The moon roof can be opened and
closed using the mechanical key.
*
(oP.609)
O The moon roof can be opened and
closed using the wireless remote con-
trol.
*
(oP.142)
O If the moon roof is closed using the door
lock linked window operation when the
alarm system is set, the alarm may be trig-
gered.
*
: These settings must be customized at
your Lexus dealer.
Q When the moon roof does not close nor-
mally
Perform the following procedure:
O If the moon roof closes but then re-opens
slightly
1
Stop the vehicle.
2
Press and hold the “CLOSE” switch.
*1
The moon roof will close, re-open and
pause for approximately 10 seconds.
*2
Then it will close again, tilt up and pause
for approximately 1 second. Finally, it
will tilt down, open and close.
3
Check to make sure that the moon roof
is completely closed and then release
the switch.
O If the moon roof tilts down but then tilts
back up
1
Stop the vehicle.
2
Press and hold the “UP” switch
*1
until
the moon roof moves into the tilt up
position and stops.
3
Release the “UP” switch once and then
press and hold the “UP” switch again.
*1
The moon roof will pause for approximately
10 seconds in the tilt up position.
*2
Then it
will adjust slightly and pause for approxi-
mately 1 second.
Finally, it will tilt down, open and close.
4
Check to make sure that the moon roof
is completely closed and then release
the switch.
*1
: If the switch is released at the incorrect
time, the procedure will have to be per-
formed again from the beginning.
*2
: If the switch is released after the above
mentioned 10 second pause, automatic
operation will be disabled. In that case,
press and hold the “CLOSE” or “UP”
switch, and the moon roof will tilt up and
pause for approximately 1 second. Then
it will tilt down, open and close. Check to
make sure that the moon roof is com-
pletely closed and then release the