4-1. Before driving
Q Information tag (manufacturer’s
label)
Gross vehicle mass
The combined weight of the driver, pas-
sengers, towing hitch, total curb mass and
drawbar load should not exceed the gross
vehicle mass by more than 100 kg (220.5
lb.). Exceeding this weight is dangerous.
Maximum permissible rear axle
capacity
The weight borne by the rear axle should
not exceed the maximum permissible axle
capacity by 15% or more. Exceeding this
weight is dangerous.
The values for towing capacity were
derived from testing conducted at sea
level. Take note that engine output and
towing capacity will be reduced at high
altitudes.
Remove the clips.
Pull the lower edge of the hitch
cover toward you and remove the
2 craws.
Pull the hitch cover toward you and
remove it.
When reattaching the cover, reverse the
Q When the gross vehicle mass limit or
maximum permissible axle capacity is
exceeded
Do not exceed the established speed
limit for towing a trailer in built-up areas
or 100 km/h (62 mph), whichever is
lower.
Failing to observe this precaution may
lead to an accident causing death or seri-
ous injury.
A
B
Q When the rear bumper strengthen-
ing material is aluminum
Ensure the steel bracket part does not
come directly in contact with that area.
When steel and aluminum come into
contact, there is a reaction similar to cor-
rosion, which will weaken the section
concerned and may result in damage.
Apply a rust inhibitor to parts that will
come in contact when attaching a steel
bracket.
Removing hitch cover
To Next Page
Loading...
