Lexus LX600 2021 - Page 289

288
4-5. Using the driving support systems
when the desired speed is reached.
In the vehicle-to-vehicle distance con-
trol mode, the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*1
or 1
mph (1.6 km/h)
*2
each time the switch is
pressed
Large adjustment: Increases or decreases
in 5 km/h (3.1 mph)
*1
or 5 mph (8 km/h)
*2
increments for as long as the switch is held
In the constant speed control mode
(oP.290), the set speed will be
increased or decreased as follows:
Fine adjustment: By 1 km/h (0.6 mph)
*1
or 1
mph (1.6 km/h)
*2
each time the switch is
pressed
Large adjustment: The speed will continue
to change while the switch is held.
*1
: When the set speed is shown in “km/h”
*2
: When the set speed is shown in “MPH”
z Increasing the set speed by the
accelerator pedal
1
Accelerate with accelerator pedal
operation to the desired vehicle
speed
2
Press the “-SET” switch
Pressing the switch changes the vehi-
cle-to-vehicle distance as follows:
1
Long
2
Medium
3
Short
If a vehicle is running ahead of you, the pre-
ceding vehicle mark will also be dis-
played.
Select a distance from the table below.
Note that the distances shown corre-
spond to a vehicle speed of 80 km/h
(50 mph). Vehicle-to-vehicle distance
increases/decreases in accordance
with vehicle speed. When the vehicle is
stopped by system control, the vehicle
stops at a certain vehicle-to-vehicle
distance depending on the situation.
Changing the vehicle-to-vehicle
distance (vehicle-to-vehicle dis-
tance control mode)
Vehicle-to-vehicle distance set-
tings (vehicle-to-vehicle dis-
tance control mode)
Distance options
Vehicle-to-vehicle
distance
Long
Approximately 50
m (160 ft.)
Medium
Approximately 40
m (130 ft.)
Short
Approximately 30
m (100 ft.)
A