Lexus LX600 2021 - Page 302

301
4
4-5. Using the driving support systems
Driving
selected, your vehicle will maintain a
set speed without controlling the vehi-
cle-to-vehicle distance. Select this
mode only when vehicle-to-vehicle
distance control mode does not func-
tion correctly due to a dirty radar, etc.
1
With the cruise control off, press
and hold the cruise control main
switch for 1.5 seconds or more.
Immediately after the switch is pressed, the
dynamic radar cruise control indicator will
come on. Afterwards, it switches to the
cruise control indicator.
Switching to constant speed control mode
is only possible when operating the switch
with the cruise control off.
2
Accelerate or decelerate, with
accelerator pedal operation, to the
desired vehicle speed (at or above
approximately 30 km/h [20 mph])
and press the “-SET” switch to set
the speed.
Cruise control “SET” indicator will come
on.
The vehicle speed at the moment the
switch is released becomes the set speed.
Adjusting the speed setting: oP.298
Canceling and resuming the speed setting:
oP.299
Q Dynamic radar cruise control can be set
when
O The shift lever is in D.
O Depending on the control mode, this item
can be set at the following speeds.
• Vehicle-to-vehicle distance control
mode: Approximately 30 km/h (20
mph) or more
• Constant speed control mode: Approxi-
mately 30 km/h (20 mph) or more
Q Accelerating after setting the vehicle
speed
The vehicle can accelerate by operating the
accelerator pedal. After accelerating, the
set speed resumes. However, during vehi-
cle-to-vehicle distance control mode, the
vehicle speed may decrease below the set
speed in order to maintain the distance to
the preceding vehicle.
Q Automatic cancelation of vehicle-to-
vehicle distance control mode
Vehicle-to-vehicle distance control mode is
automatically canceled in the following situ-
ations.
O Actual vehicle speed falls below approxi-
mately 25km/h (16 mph).
O VSC is activated.
O Active TRC is activated for a period of
time.
O When the VSC or Active TRC system is
turned off.
O The sensor cannot detect correctly
because it is covered in some way.
O When the brake control or output