Lexus LX600 2021 - Page 321

320
4-5. Using the driving support systems
screen when an obstacle is detected
while magnified display is shown.
(oP.346)
Use the meter control switches to turn
on/off the function. (oP.125)
1
Press the meter control switch to
select .
2
Press the meter control switch to
select and then press .
When the Lexus parking assist-sensor
function is disabled, the Lexus parking
assist-sensor OFF indicator (oP.118) illu-
minates on the multi-information display.
To re-enable the system, select on the
multi-information display, select and
turn it on.
If the system is disabled, it will remain off
even if the engine switch is turned to ON
after the engine switch has been turned off.
Turning Lexus parking assist-
sensor on/off
WARNING
Q Cautions regarding the use of the
system
There is a limit to the degree of recogni-
tion accuracy and control performance
that this system can provide, do not
overly rely on this system. The driver is
always responsible for paying attention
to the vehicle’s surroundings and driving
safely.
Q To ensure the system can operate
properly
Observe the following precautions.
Failing to do so may result in the vehicle
being unable to be driven safely and pos-
sibly cause an accident.
O Do not damage the sensors, and
always keep them clean.
O Do not attach a sticker or install an
electronic component, such as a
backlit license plate (especially fluo-
rescent type), fog lights, fender pole or
wireless antenna near a radar sensor.
O Do not subject the surrounding area of
the sensor to a strong impact. If sub-
jected to an impact, have the vehicle
inspected by your Lexus dealer. If the
front or rear bumper needs to be
removed/installed or replaced, con-
tact your Lexus dealer.
O Do not modify, disassemble or paint
the sensors.
O Do not attach a license plate cover.
O Keep your tires properly inflated.
Q When to disable the function
In the following situations, disable the
function as it may operate even though
there is no possibility of a collision.
O Failing to observe the warnings above.
O A non-genuine Lexus suspension
(lowered suspension, etc.) is installed.
Q Notes when washing the vehicle
Do not apply intensive bursts of water or
steam to the sensor area.
Doing so may result in the sensor mal-
functioning.
O When using a high pressure washer to
wash the vehicle, do not spray the sen-
sors directly, as doing so may cause a
sensor to malfunction.