4
4-5. Using the driving support systems
Driving
Symptom Likely cause Solution
The image is difficult to see
x The vehicle is in a dark
area
x The temperature around
the lens is either high or
low
x The outside temperature is
low
x There are water droplets
on the camera
x It is raining or humid
x Foreign matter (mud, etc.)
is adhering to the camera
x Sunlight or headlights are
shining directly into the
camera
x The vehicle is under fluo-
rescent lights, sodium
lights, mercury lights, etc.
Back up while visually check-
ing the vehicle’s surround-
ings. (Use the monitor again
once conditions have been
improved.)
The procedure for adjusting
the picture quality of the
Multi-terrain Monitor sys-
tem is the same as the proce-
dure for adjusting the screen
display. Refer to the “Multi-
media Owner’s Manual”.
The image is blurry
Dirt or foreign matter (such
as water droplets, snow,
mud, etc.) is adhering to the
camera.
Flush the camera with a large
quantity of water and wipe
the camera lens clean with a
soft and wet cloth.
Rear camera: Operate the
dedicated camera cleaning
washer and clean the camera
lens. (oP.253)
The image is out of alignment
The camera or surrounding
area has received a strong
impact.
Have the vehicle inspected
by your Lexus dealer.
The guide lines are very far
out of alignment
The camera position is out of
alignment.
Have the vehicle inspected
by your Lexus dealer.
x The vehicle is tilted. (There
is a heavy load on the vehi-
cle, tire pressure is low due
to a tire puncture, etc.)
x The vehicle is used on an
incline.
If this happens due to these
causes, it does not indicate a
malfunction.
Back up while visually check-
ing the vehicle’s surround-
ings.
To Next Page
Loading...
