6
6-3. Do-it-yourself maintenance
Maintenance and care
display.
Drive straight (with occasional left
and right turns) at approximately
40 km/h (25 mph) or more for
approximately 10 to 30 minutes.
Registration is complete when the tire
pressure warning light turns off and the
inflation pressure of each tire is displayed
on the multi-information display.
Registration may take longer than approxi-
mately 1 hour in certain situations, such as
when the vehicle is stopped for a long time
at traffic lights, etc.
Initialize the tire pressure warning
system. (oP.554)
Q When registering ID codes
O ID code registration is performed while
driving at a vehicle speed of approxi-
mately 40 km/h (25 mph) or more.
O Before performing ID code registration,
make sure that no wheels with tire pres-
sure warning valve and transmitters
installed are near the vehicle.
O Make sure to initialize the tire pressure
warning system after registering the ID
codes. If the system is initialized before
registering the ID codes, the initialized
values will be invalid.
O As the tires will be warm when registra-
tion is completed, make sure to allow the
tires to cool before performing initializa-
tion.
O ID codes can be registered by yourself,
but depending on the driving conditions
and driving environment, registration
may take some time to complete.
Q Canceling ID code registration
O To cancel ID code registration after it has
been started, select “Change Wheel Set”
on the multi-information display and
press and hold again.
O If ID code registration has been can-
celed, the tire pressure warning light will
blink for approximately 1 minute when the
engine switch is turned to ON and then
illuminate. The tire pressure warning sys-
tem will be operational when the tire
pressure warning light turns off.
O If the warning light does not turn off even
after several minutes have elapsed, ID
code registration may not have been
canceled correctly. To cancel registra-
tion, perform the ID code registration
start procedure again and then turn the
engine switch off before driving.
Q If ID codes are not registered properly
O In the following situations, ID code regis-
tration may take longer than usual to be
completed or may not be possible. Nor-
mally, registration completes within
approximately 30 minutes.
If ID code registration is not complete
after driving for approximately 30 min-
utes, continue driving for a while.
• Vehicle is not parked for approximately
20 minutes or more before driving
• Vehicle is not driven at approximately 40
km/h (25 mph) or more
• Vehicle is driven on unpaved roads
• Vehicle is driven near other vehicles and
system cannot recognize tire pressure
warning valve and transmitters of your
vehicle over those of other vehicles
• Wheel with tire pressure warning valve
and transmitter installed is inside or near
the vehicle
If registration does not complete after driv-
ing for 1 hour or more, perform the ID code
registration procedure again from the
beginning.
O If the vehicle is reversed during registra-
To Next Page
Loading...
