1
1-2. Child safety
For safety and security
*1
: Move the front seat fully rearward. If the
passenger seat height can be adjusted,
move it to the upper most position.
*2
: Adjust the seatback angle to the most
upright position. When installing a for-
ward-facing child seat, if there is a gap
between the child seat and the seat-
back, adjust the seatback angle until
good contact is achieved.
*3
: If the head restraint interferes with your
child restraint system, and the head
restraint can be removed, remove the
head restraint.
Otherwise, put the head restraint in the
upper most position.
*4
: Use only a front-facing child restraint
system.
*5
: Adjust the seat to the lowest position.
(Left-hand drive vehicles for 4-passen-
ger models only)
Q Detail information for child restraint systems installation
*2, 3
*2, 3
Suitable for “universal” category
child restraint system fixed with
the seat belt.
Suitable for forward-facing “uni-
versal” category child restraint
system fixed with the seat belt.
Suitable for i-Size and ISOFIX
child restraint system.
Includes a top tether anchorage
point.
Never use a rear-facing child
restraint system on the front pas-
senger seat.
Seating position
Seat position num-
ber
*1
Seating position
suitable for univer-
sal belted (Yes/No)
Yes
Forward-
facing
only
Yes Yes Yes Yes Yes
i-Size seating posi-
tion (Yes/No)
No Yes No Yes No No
Seating position
suitable for lateral
fixture (L1/L2/No)
No No No No No No
To Next Page
Loading...
