1-2. Child safety
Q Installing child restraint system
using a seat belt
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
If the child restraint system on hand is
not within the “universal” category (or
the necessary information is not in the
table), refer to the “Vehicle List” pro-
vided by the child restraint system
maker for various possible installation
positions, or check the compatibility
after asking the retailer of the child
restraint system. (oP.64, 69, 75)
If installing the child restraint sys-
tem to the front passenger seat is
unavoidable, refer to P.62 for the
front passenger seat adjustment.
Adjust the seatback angle to the
most upright position. When install-
ing a forward-facing child seat, if
there is a gap between the child
seat and the seatback, adjust the
seatback angle until good contact
is achieved.
If the head restraint interferes with
the child restraint system installa-
tion and the head restraint can be
removed, remove the head
restraint. Otherwise, put the head
restraint in the upper most position.
(oP.183)
ISOFIX lower anchorage
attachment
P.84
Top tether anchorage
attachment
P.86
Installation method Page
Child restraint system fixed with
a seat belt
To Next Page
Loading...
