1-2. Child safety
Q ISOFIX lower anchorages (ISO-
FIX child restraint system)
X 5-passenger and 7-passenger
models
Lower anchorages are provided for
the second outboard seats. (Marks dis-
playing the location of the anchorages
are attached to the seats.)
X 4-passenger models
Lower anchorages are provided for
the each second seats. (Marks display-
ing the location of the anchorages are
attached to the seats.)
Q Installation with ISOFIX lower
anchorage (ISOFIX child restraint
system)
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
If the child restraint system on hand is
not within the “universal” category (or
the necessary information is not in the
table), refer to the “Vehicle List” pro-
vided by the child restraint system
maker for various possible installation
positions, or check the compatibility
after asking the retailer of the child
restraint system. (oP.64, 69, 75)
Adjust the seatback angle to the
most upright position. When install-
ing a forward-facing child seat, if
there is a gap between the child
seat and the seatback, adjust the
seatback angle until good contact
is achieved.
If the head restraint interferes with
the child restraint system installa-
tion and the head restraint can be
removed, remove the head
restraint. Otherwise, put the head
restraint in the upper most position.
(oP.183)
O When a junior seat (booster seat) is
installed, always ensure that the shoul-
der belt is positioned across the center
of the child’s shoulder. The belt should
be kept away from the child’s neck, but
not so that it could fall off the child’s
shoulder.
O Follow all installation instructions pro-
vided by the child restraint system
manufacturer.
Child restraint system fixed with
an ISOFIX lower anchorage
To Next Page
Loading...
