Lightware UMX-TPS-TX100 Series

 UMX-TPS-TX100 series – User's Manual 88

Command and Response
Î <gw_address>
Í <gw_address>
Example
Î 
Í 

INFO: Serial port numbering can be found in the Port Numbering section.
Protocol Setting
Command and Response
Î <port>.ControlProtocol=<protocol>
Í <port>.ControlProtocol=<protocol>
Parameters
 Parameter description Value Parameter value
<protocol>
Control protocol which is
applied on the selected
serial port
0 
1 
Example
Î 
Í 
BAUD Rate Setting
Command and Response
Î <port>.Baudrate=<baudrate>
Í <port>.Baudrate=<baudrate>
Parameters
 Parameter description Value Parameter value
<baudrate> BAUD rate value
0 4800
1 7200
2 9600
3 14400
4 19200
5 38400
6 57600
7 115200
Example
Î 
Í 
Databits Setting
Command and Response
Î <port>.DataBits=<databits>
Í <port>.DataBits=<databits>
Parameters
 Parameter description Value Parameter value
<databits> Databits value
8 8
9 9
Example
Î 
Í 



