Lightware UMX-TPS-TX100 Series

8. Firmware Upgrade UMX-TPS-TX100 series – User's Manual 105
Step 4. 
Click on the Start Update button to start the procedure. The status is shown in percent in the right side of the
device line and the status of the all procedures in the lower light green progress bar.
Firmware upgrade is in progress

Step 5. 

Firmware upgrade procedure is done


been chosen in the parameters window, all device settings will be erased. In the case of factory reset you
can save the settings of the device in the Lightware Device Controller software and restore it later. See the
details in the section.

1
Start of the Upgrade

2
Backup

Content of Backup File
section.
3
Upgrade

4
Factory reset

5
Conversion / Restore



When the factory default option is enabled in the Parameters window, the conversion / restore procedure
will not be performed!
6
End


                 
              
Factory default option enabled.



