Lightware UMX-TPS-TX100 Series - Sending Pronto Hex Codes in Little-Endian Format Via IR Port; Sending Pronto Hex Codes in Big-Endian Format Via IR Port

 UMX-TPS-TX100 series – User's Manual 94


Command and Response
Î <output_port>:sendProntoHex(<hex_code>)
Í <output_port>:sendProntoHex
Parameters
 Parameter description Parameter values
<output_port>
Output port of the
Infrared interface
Local Infra output: D1; TPS Infra output: D2
<hex_code>
Pronto hex format
code
Accepts maximum 765 character-long code in hexadecimal
format (0-9; A-F; a-f) without space character in little-endian
system.
INFO: This command can send exactly one pronto hex message. The header of the IR code contains the

For more details about the pronto hex codes see IR Interface section.
Example
Î 
015003F0015001500150015001500150015001500150 0150015003F0015003F001500
3F00150015001500150 015001 500150015001500150015003F0015003F0015003F00150015001500
150015001500150015001500150015001500150015001500150015003F0015003F0015003F0015003
F0015003F0015000207A900A8001500150015006E0E)
Í 
TIPS AND TRICKS: Download a code which belongs to your controlled device from a web database from
the Internet. The downloaded codes are mostly in little-endian format.


Command and Response
Î <output_port>:sendProntoHexBigEndian(<hex_code>)
Í <output_port>:sendProntoHexBigEndian
Parameters
 Parameter description Parameter values
<output_port>
Output port of the
Infrared interface
Local Infra output: D1; TPS Infra output: D2
<hex_code>
Pronto hex format
code
Accepts maximum 765 character-long code in hexadecimal
format (0-9; A-F; a-f) without space character in big-endian
system.
INFO: This command can send exactly one pronto hex message. The header of the IR code contains the

For more details about the pronto hex codes see IR Interface section.
Example
Î   
003f00150015001500150015001500150015001500150015003f0015003f0015003f001500150015001
50015001500150015001500150015003f0015003f0015 003f001500150015001500150015001500150
01500150015001 500150015001500150015003f0015003f0015003f0015003f0015 003f0015070200a
900a80015001500150e6e)
Í 
TIPS AND TRICKS: Learning raw IR code with a terminal program:
Step 1. Connect to the UMX-TPS-TX140-Plus device with a terminal program.
Step 2. Push the desired button of the remote control to scan the raw IR code.
Step 3. Remove all the non-hexadecimal characters (e.g. spaces, h characters etc.) from the code.
The pronto hex code which learned by a Lightware device is big-endian format.



