Loop Telecom IP6610 User Manual

Chapter 16 VLAN
78
Press Enter.
Set virtual channel pvc2 with DLCI 101 by keying in the command set wan1 pvc dlci 2 101.
Press Enter.
Enable all interfaces to be in bridge mode by keying in the command add bridge. Press Enter.
If the VLAN feature is disabled (turned off) you must enable it. Enable the VLAN feature by keying in the
command add vlan. Press Enter.
You must create a VID for each port. To create VID:3 key in the command set vlan create 3 and press
Enter. To create VID:5 key in the command set vlan create 5 and press Enter.
You must set virtual channel pvc1 to be a tagged member for VID:3 VLAN1. Key in the command

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English