Chapter 21 Appendix A: Operation Commands
124
Command: >del dhcp host option_code
Syntax: del dhcp host option_code host_name code
Explanation:
Parameters: host_name
code
Command: >delete filter
Syntax: delete filter list_name index
Explanation: deletes filter entries from a specific list
Parameters: list_name name of the list the entry to be deleted from. Either list-1, list-2, list-3,
or list- 4.
index index of entry to be deleted
Command: >delete napt forwarding
Syntax: delete napt forwarding name
Explanation: deletes the NAPT forwarding entry
Parameters: name the name of deleting entry
Command: >delete nat address
Syntax: delete nat address index
Explanation: deletes the NAT public ip address pool
Parameters: index the index of the pool to be deleted. The possible value range from 1 to 8.
Command: >delete nat static
Syntax: delete nat static public_ip
Explanation: deletes a static translation entry.
Parameters: public_ip the public ip address in the static translation entry to be deleted
Command: delete rate_limit
Syntax:
delete rate_limit policy_num
Explanation:
Deletes the QoS policy index by policy_num from WAN1 policy list.
Parameters:
policy_num policy index number; each policy is index by policy number in the
policy list
Command: >delete route
Syntax: delete route net_addr mask
Explanation: Delete a static route from IP6610’s static routing table.
Parameters: net_addr network address of the route entry
mask subnet mask of the network
Command: >delete sntp server
Syntax: delete sntp server index
Explanation: deletes the specified SNTP server
Parameters: index the index number of the server
Command: >delete svlan
To Next Page
Loading...
