Loop Telecom IP6610 User Manual

Chapter 21 Appendix A: Operation Commands
155
Command: >set DS1 frame
Syntax: set DS1 frame framing_mode
Explanation: Set DS1 framing type.
Parameters: framing_mode D4/ESF/ESF&DS1.403
Command: >set DS1 code
Syntax: set DS1 code coding_mode
Explanation: Set DS1 line coding mode.
Parameters: coding_mode AMI/B8ZS
Command: >set DS1 lbo
Syntax: set DS1 lbo setting
Explanation: Set DS1 line built out.
Parameters: setting 0dB/-7.5dB/-15dB
Command: >set DS1 idle_code
Syntax set DS1 idle_code idle_code
Explanation: Any DS0 channel, which is not assigned to a WAN port, is an idle channel. An idle code is
transmitted on idle DS0 channels. Users may program the idle channel to any bit pattern
from 00H to FFH.
Parameters: idle_code 0x00~0xFF
Command: >set DS1 yel setting
Syntax: set DS1 yel setting
Explanation: Enable/disable DS1 YEL function.
Parameters: setting on/off
Command: >set DS1 inband
Syntax: set DS1 inband setting
Explanation: Enable/disable DS1 inband loopback code detective function.
Parameters: setting on/off
Command: >set DS1 address
Syntax: set DS1 address setting
Explanation: Set DS1 address.
Parameters: setting CSU/TE
Command: >set DS1 primary_clk
Syntax: set DS1 primary_clk clock_source
Explanation: Select DS1 primary clock source.
Parameters: clock_source line/internal
Command: >set DS1 secondary_clk
Syntax: set DS1 secondary_clk clock_source
Explanation: Select DS1 secondary clock source.
Parameters: clock_source line/internal

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English