Transport
- 35 -
04.19 909.1709.9-05
9 Mains connection
The machine complies with the requirements of EN / IEC
61000-3-12 provided that the maximum network imped-
ance Zmax is smaller or equal to the impedance Zmax
of the machine at the connecting point to the public low-
voltage network specied in the technical specications.
The tter or user of the machine is responsible to en-
sure that, where applicable by coordination with the pub-
lic power supplier, the machine is only connected to a
public low-voltage network when the maximum network
impedance Zmax is smaller or equal to the impedance
Zmax of the machine specied in the technical speci-
cations. WARNING: Permanent use of the machine at
maximum performance with an actual switching period
that is greater than fteen percent leads to the limit val-
ues for Rsce dened according to IEC 61000-3-12 being
exceeded, If the machine is to be operated with a re-
spectively high loading on a public low-voltage network,
the permission of the power supplier must be obtained
by the user with regard to the connection of the device.
For units (type T 220) you basically do not have to con-
sider specic aspects regarding the power supply.
10 Noise emission
The noise level of the unit is less than 70 dB(A), meas-
ured under standard load in accordance with EN 60974-
1 in the maximum working point.
11 Transport
For transport using mechanical lifting
equipment (e.g. crane, ...) only the han-
dle may be used as the hoisting point.
Use suitable load-carrying equipment.
Do not lift the by the housing using a
fork-lift truck or similar.
The carrying strap is exclusively for the
transport by a person.
To Next Page
Loading...
Need help?
General
