Magtrol DSP7000 - Figure 8-4 Filter Channel Setup Menu; Figure 8-5 Offset and Gain Setup Menu; Figure 8-6 External Alarm Setup

90
Magtrol Model DSP7000 Dynamometer ControllerChapter 8 – Optional Equipment
operation
3. Select I/O. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT PID
TORQUE SPEED USER DISPLAY
FILTER SETUP
I/O CARD X
CHANNEL1
CHANNEL2
X HZ X HZ
Figure 8–4 Filter Channel Setup Menu
4. Press TORQUE UNITS button until the desired filter for channel 1 is reached.
5. Press SCALE P button until the desired filter for channel 2 is reached.
6. Press SHIFT. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT PID
TORQUE SPEED USER DISPLAY
IO CARD X
000.00
CHX OFFSET
±0.000 UNIT
GAIN
±0.000 UNIT/V
Figure 8-5 Offset and Gain Setup Menu
7. Press TORQUE UNITS button and use  and  buttons and the Decrease/Increase dial to
set the offset for channel 1.
8. Press SCALE P button and use  and  buttons and the Decrease/Increase dial to set the
gain for channel 1.
9. Press SHIFT.
10. Press TORQUE UNITS button and use  and  buttons and the Decrease/Increase dial to
set the offset for channel 2.
11. Press SCALE P button and use  and  buttons and the Decrease/Increase dial to set the
gain for channel 2.
12. Press SHIFT. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT PID
TORQUE SPEED USER DISPLAY
IOX USE DI3 AS EXTERNAL ALARM? XXX

Figure 8–6 External Alarm Setup
13. Press SCALE I button to select yes or no.
14. Press SHIFT. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT PID
TORQUE SPEED USER DISPLAY
IO X
USE RL1 AS ALARM CONTACT? XXX
