Magtrol DSP7000 User Manual

22
Magtrol Model DSP7000 Dynamometer ControllerChapter 3 – Installation/Configuration
SETUP
3.2.2 HySTereSiS DynaMoMeTer SeTup
3.2.2.1 Hardware Connection
AC Mains
Motor
Under
Test
Hysteresis Dynamometer (HD)
DSP7001
DYNAMOMETER
CONTROLLER
USB
PC
M-TEST
No Connection
Figure 3–8 Hysteresis Dynamometer Setup
3.2.2.2 Software Conguration
1. Turn on the DSP7000 and proceed to the dynamometer configuration menu. See Section
3.2.1 – Dynamometer Configuration Menu.
2. Press POWER UNITS until HD is reached.
3. Press MAX SPEED until the desired input unit for TSC.
4. Press SCALE I to add a filter if desired.
5. Press SHIFT. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT PID
TORQUE SPEED USER DISPLAY
TSC1 MAX TORQUE
XXXX
Figure 3–9 Hysteresis Setup Menu
6. Press TORQUE UNITS button and use  and  buttons and Decrease/Increase dial to set
desired max torque for TSC1.
7. Press SHIFT 3 times to complete the initial setup and return to the main menu.

Magtrol DSP7000 Specifications

General

Brand	Magtrol
Model	DSP7000
Category	Controller
Language	English