Magtrol DSP7000 User Manual

31
Magtrol Model DSP7000 Dynamometer Controller
Chapter 3 – Installation/Configuration
SETUP
3.2.9 eDDy-CurrenT DynaMoMeTer wiTH powDer Brake DynaMoMeTer (TanDeM SeTup)
3.2.9.1 Hardware Connection
USB
PC
M-TEST
Clutch
(EK)
DSP
7002
Dynamometer
Controller
Transformer
Powder Brake
Dynamometer (PB)
Excitation
Torque
DES Power Supply
TSC 401
Torque/Speed
Conditioner
Eddy-Current Brake
Dynamometer (WB)
Excitation
Torque
TSC 401
Torque-Speed
Conditioner
DES Power Supply
Speed
Figure 3–23 Eddy-Current Dynamometer with Powder Brake Dynamometer (Tandem Setup)
3.2.9.2 Software Conguration
1. Turn on the DSP7000 and proceed to the dynamometer configuration menu. See Section
3.2.1 – Dynamometer Configuration Menu.
2. Select POWER UNITS until WB is reached for TSC1.
3. Press MAX SPEED button and use  and  buttons and Decrease/Increase dial to set
desired scale factor.
4. Press SCALE I to add a filter if desired.
5. Press SHIFT to get to the TSC1 Eddy-Current Setup Menu. See Figure 3-16 TSC1 Eddy-
Current Setup Menu.
6. Press TORQUE UNITS button and use  and  buttons and Decrease/Increase dial to set
desired max torque. Press SCALE P button use  and  buttons and Decrease/Increase
dial to set desired nominal speed. Press SHIFT 3 times to complete setup and return to the
main menu.
7. Press TSC to switch to TSC2 setup and proceed to the dynamometer configuration menu.
8. Select POWER UNITS until PB is reached for TSC2.
9. Press MAX SPEED button and use  and  buttons and Decrease/Increase dial to set
desired scale factor.
10. Press SCALE I to add a filter if desired.
11. Press SHIFT to get to the TSC2 Powder Brake Setup Menu. See Figure 3-14 TSC2 Powder
Brake Setup Menu.
12. Press TORQUE UNITS button and use  and  buttons and Decrease/Increase dial to set
desired max torque.
13. Press SHIFT 2 times. The menu will appear as shown in Figure 3–21 Tandem Setup Menu.

Magtrol DSP7000 Specifications

General

Brand	Magtrol
Model	DSP7000
Category	Controller
Language	English