14
Magtrol Model DSP7000 Dynamometer ControllerChapter 2 – Controls
GENERAL
INFORMATION
Top Row Bottom Row
POWER BRAKE STATUS (ON or OFF)
TORQUE SET POINT (TORQUE)
SPEED SET POINT (SPEED)
USER DISPLAY
P
I
D
2.3.1 contraSt SEttingS
The DSP7000 is shipped with the Contrast Setting at zero (lowest) in order to prolong display life.
If it is necessary to increase the Contrast for improved readability, execute the following steps:
1. Press SHIFT.
2. Press SETUP button.
3. Select SYSTEM
3. Select CONTR until desired brightness is reached.
4. Press SHIFT 2 times to return to main menu.
Note: Make sure the lowest possible setting is used to achieve desired
result. Using a setting higher than necessary may cause display
segments to burn-in over a period of time, resulting in uneven
illumination from segment to segment.
2.3.2
StatuS diSPlay MESSagES
Message Meaning
SHIFT Shift button was pressed.
MAX SPEED Maximum motor RPM.
UNITS Torque unit of measurement.
REMOTE Remote control via PC enabled.
RAMP DOWN Decrease motor speed by increasing load on motor.
RAMP UP Increase motor speed by decreasing load on motor.
SAVING Saves current conguration of unit to non-volatlie memory.
RAMP DU Decrease motor speed and then increase motor speed
POWER UNITS
UNITS Torque units
To Next Page
Loading...
Need help?
General