Magtrol DSP7000 - Figure 3-16 TSC1 Eddy-Current Setup Menu; Figure 3-17 TSC1 Powder Brake Setup Menu

To Next Page

To Previous Page

Magtrol Model DSP7000 Dynamometer ControllerChapter 3 – Installation/Conﬁguration

SETUP

4.a If using an Eddy Current Dynamometer, press SHIFT. The display should appear as follows:

POWER

BRAKE STATUS SET POINT SET POINT PID

TORQUE SPEED USER DISPLAY

TSC1 MAX TORQUE NOMINAL SPEED

XXXX XXXX.X

Figure 3–16 TSC1 Eddy-Current Setup Menu

Press the TORQUE UNITS button and use  and  buttons and Decrease/Increase dial to

set desired max torque. Press the SCALE P button and use  and  buttons and Decrease/

Increase dial to set desired nominal speed. Press SHIFT 3 times to complete the initial setup

and return to the main menu.

4.b If using a Powder Brake Dynamometer, press SHIFT. The display should appear as follows:

POWER

BRAKE STATUS SET POINT SET POINT PID

TORQUE SPEED USER DISPLAY

TSC1 MAX TORQUE

XXXX

Figure 3-17 TSC1 Powder Brake Setup Menu

Press the TORQUE UNITS button and use  and  buttons and Decrease/Increase dial to

set desired max torque. Press SHIFT 3 times to complete the initial setup and return to the

main menu.