Magtrol DSP7000 User Manual

ii
The contents of this manual are subject to change without prior notice. Should revisions be necessary, updates to all
Magtrol User’s Manuals can be found at Magtrol’s web site at www.magtrol.com/support/manuals.htm.
Please compare the date of this manual with the revision date on the web site, then refer to the manual’s Table of
Revisions for any changes/updates that have been made since this edition.
REVISION DATE
2nd Edition revision L– January 2017
TABLE OF REVISIONS
Revisions To This Manual
Date Edition Change Section(s)
01/05/17 2 nd Edition rev. L I/O Card specications updated. 8.1
04/05/16 2 nd Edition rev. K Torque Commands updated. 7.4.6
08/10/15 2 nd Edition rev. J USB driver setup for Windows operating system updated. 7.1.1
07/07/15 2 nd Edition rev. H Installation instructions and commands updated
throughout chapter.
Chapter 7
07/07/15 2 nd Edition rev. H Setting tare function instructions updated. 6.7.1
07/07/15 2 nd Edition rev. H Alarm instuctions and commands updated throughout
chapter.
Chapter 5
06-09-15 2 nd Edition rev. G Figure 2-12 RS-232 Interface drawing updated. 2.4.4
06/19/14 2 nd Edition rev. F A/D Sample Rate changed from 7812.5 KHz to 7812.5 Hz. 10.3
03/27/14 2 nd Edition rev. E Miscellaneous Commands updated. 7.4.7
10/28/13 2 nd Edition rev. D Speed commands table updated.
Figure 4-1 updated for new rmware.
Section updated for new rmware.
7.4.5
4.3.1
6.6
07/11/13 2 nd Edition rev. C Note added to Calibration Frequency procedure. 9.3.4
07/03/13 2 nd Edition rev. B Step number 5 updated in Calibration Procedure of Digital
to Analog Converters.
9.3.3
07/03/13 2 nd Edition rev. B Step number 4 updated in Calibration Prodedure of
Analog to Digital Converters.
9.3.2
05/23/13 2 nd Edition rev. A Calibration procedure of Analog to Digital Converters
updated.
9.3.2
05/23/13 2 nd Edition rev. A Digital input and output added to specications. 8.1
03/09/13 2 nd Edition Torque invert signal added. B.3.4
03/09/13 2 nd Edition Prcedure for setting the scale factor updated. 10.2.1.1, 10.2.1.2,
10.2.1.3
03/09/13 2 nd Edition Calibration Procedure updated. 9.3, 9.3.3
03/09/13 2 nd Edition New drawing added. 8.2.3, 8.2.4
03/09/13 2 nd Edition Pin 25 updated to Alarm Relay 2 Common. 8.1.2
03/09/13 2 nd Edition QDS1,xx.xx, QDS2,xx.xx; QIS1,xx.xx, QIS2,xx.xx;
QPS1,xx.xx, QPS2,xx.xx commands updated.
7.4.6
03/09/13 2 nd Edition NDSI1,#, NDSI2,#; NISI1,#, NISI2,#; NPSI1,#, NPSI2,#
commands updated.
7.4.5

Magtrol DSP7000 Specifications

General

Brand	Magtrol
Model	DSP7000
Category	Controller
Language	English