Magtrol DSP7000 User Manual

36
Magtrol Model DSP7000 Dynamometer ControllerChapter 3 – Installation/Configuration
SETUP
POWER
BRAKE STATUS SET POINTSET POINTPID
TORQUE SPEED USER DISPLAY
SOURCE
AI 1
SPEED ALARM
XXXX
Figure 3–30 AI 1 Menu
2. Press SCALE P button and use  and  buttons and Decrease/Increase dial to set the Speed
Alarm.
3. Press SHIFT 3 times to complete the setup and return to the main menu.
3.5 CONFIGURE COMMUNICATION
3.5.1 gpiB aDDreSS
1. Starting from the main menu, press SHIFT.
2. Press SETUP to display the setup menu.
3. Press SCALE P to display the System setup menu. The display should appear as follows:
POWER
BRAKE STATUS SET POINTSET POINTPID
TORQUE SPEED USER DISPLAY
CONTR
GPIB ADDR RS232
MODE
XX
XXXXXX XXXX
Figure 3–31 System Setup Menu
4. Press TORQUE UNITS button to select the desired GPIB Address.
5. Press SHIFT 2 times to complete the setup and return to the main menu.
3.5.2 rS-232 inTerfaCe
1. Starting from the main menu, press SHIFT.
2. Press SETUP to display the setup menu.
3. Press SCALE P to display the System Setup Menu. See figure 3-31 System Setup Menu.
4. Press MAX SPEED button to select the desired RS-232 interface.
5. Press SHIFT 2 times to complete the setup and return to the main menu.

Magtrol DSP7000 Specifications

General

Brand	Magtrol
Model	DSP7000
Category	Controller
Language	English