Magtrol DSP7000 User Manual

21
Magtrol Model DSP7000 Dynamometer Controller
Chapter 3 – Installation/Configuration
SETUP
3.2.1 DynaMoMeTer ConfiguraTion Menu
To reach the dynamometer configuration menu:
1. Turn on DSP7000 power. See Section 3.1 – Powering Up the DSP7000.
2. Press SHIFT. The word “SHIFT” will appear in the display.
3. Press the SETUP button. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT PID
TORQUE SPEED USER DISPLAY
DYNO

I/O

SYSTEM

USER

Figure 3–5 Setup Menu
4. Select DYNO. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT PID
TORQUE SPEED USER DISPLAY
MAXPOWER

DYNAMOMETER

ENCODERS

ALARMS

Figure 3-6 Dyno Setup Menu
5. Select DYNAMOMETER. The display should appear as follows:
POWER
BRAKE STATUS SET POINT SET POINT PID
TORQUE SPEED USER DISPLAY
TSCX
HD
INPUT UNITS FILTER
N.m
NONE
Figure 3–7 Dynamometer Configuration Menu
6. Pressing the POWER UNITS button allows selection of the preferred testing device (HD,
WB, PB or HD5) for TSC1. Pressing the MAX SPEED button allows selection of the input
units (N·m, oz·in, oz·ft, lb·in, lb·ft, g·cm, kg·cm, mN·m, cN·m). Pressing SCALE I allows
selection of a filter if desired. Refer to the remainder of this chapter for more detailed
instructions on setup and configuration of the different testing devices.
NOTE: For information on Filters, see Section 3.3 – Torque Filter Setup.

Magtrol DSP7000 Specifications

General

Brand	Magtrol
Model	DSP7000
Category	Controller
Language	English