Manitowoc Published 05-09-17, Control # 014-28 3-7
16000 SERVICE/MAINTENANCE MANUAL ELECTRIC SYSTEM
Alphabetical Index of Components
Find the desired component item in this index. Check the
component item node location, then refer to indicated node
to find the test voltage for that item.
Abbreviations
The following abbreviations are used in test voltage tables:
Component Location
Accessory System Components Node 3 & 4
Alarms Nodes1, 3 & 5
Air Conditioning Clutch Node 1
Auto Lube Pumps Node 5
Block Up Limit (Boom) Node 20
Block Up Limit (Luffing Jib) Node 21
Boom Suspension Load Pin Node 5
Cab Switches and Controls Nodes 1 & 2
Cab Power Node 0
Cab Tilt Node 3
Control Handles Nodes 1 & 2
Counterweight Pins Node 4
Boom/Mast Hoist (Drum 4) Components Nodes 3, 4 5 & 6
Engine Control Module Node 0
Engine Fuel Level Sensor Node 5
Engine Cooler Fan/Acc Enable Solenoid Node 5
Filters Nodes 3
Hydraulic Fluid Level and Temperature Node 5
Hydraulic Vacuum Switch Node 3
Limits Nodes 5 & 6
Load Hoist (Drum 1) Components Nodes 3, 4 & 6
Load Hoist (Drum 2) Components Nodes 3, 4 & 5
Load/Luffing (Drum 3) Components Node 6
Mast Nodes 4
MAX-ER Node 7
Pressure Senders Nodes 3, 4 & 5
Rigging Winch Node 4
Rotating Bed Level Sensor Node 5
Swing Components Nodes 3 & 5
Throttle (Hand and Foot) Node 2
Travel Components Nodes 4 & 5
Wind Speed Indicator (Boom) Node 20
Wind Speed Indicator (Jib) Node 21
AC = Alternating Current
A/C = Air Conditioning
AI = Analog Input
AO = Analog Output
AUX. = Auxiliary
CAN = Controller Area Network
CANH = Controller Area Network - High
CANL = Controller Area Network - Low
CHA or CHB = Channel A or B
DC = Direct Current
DI = Digital Input
DO = Digital Output
EC = Encoder Control
ENC = Encoder Number Count
GND = Ground
ID = Identification
I/O = Input/Output
L.E.D. = Light Emitting Diode
Max. = Maximum
Min. = Minimum
N/A = Not Applicable
N/C = No Connection
NO = Number
NS = Node Select
Opt. = Optional
RCL = Rated Capacity Indicator/Limiter
V = Volt or Volts
VDC = Volts Direct Current
W=Wire
To Next Page
Loading...
