Manitowoc Published 05-09-17, Control # 014-28 1-19
16000 SERVICE/MAINTENANCE MANUAL INTRODUCTION
Display Screens
See Figure 1-11 for the following procedure.
The display screens contain the RCL display and main
display. Use the menu screens to selected RCL and crane
functions.
Electrical Power to Operator’s Cab
See Figure 1-12 for the following procedure.
When key-operated engine switch is in STOP position,
voltage is available to operate dome light switch, and radio/
clock. When key-operated engine switch is placed in RUN
position, power is available to the following relays:
• Engine control module (ADM2)
• CAN-bus system power relay (CAN PWR)
• CAN-bus system ground relay (CAN GND)
• Cab power relay (CAB PWR). When cab power relay is
enabled, power is available to operate crane controls.
• Air conditioning system relay (A/C CLUTCH)
To Next Page
Loading...
