Starting the engine for driving / switching it off
4.1 Starting the engine from the driver's cab
Operating Manual GMK6300L 3 112 xxx en 4 - 17
xx.xx.xxxx
H
If the lamp (1) does not go out, there is a malfunction in the flame start
system;
à p. 7 - 27.
• Wait until the lamp (1) goes out.
• Do not press the accelerator.
• Turn the ignition key to position 3 and hold it there until the engine starts.
• Let go of the ignition key after the engine starts.
• If the engine does not start, release the ignition key after approx.
15 seconds and wait one minute before trying again.
H
If the engine does not start after multiple attempts; à Malfunctions on the
engine
, p. 7 - 27.
To Next Page
Loading...
