Starting the engine for driving / switching it off
4.1 Starting the engine from the driver's cab
4 - 16 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
H
If the engine is equipped with a flame start system; Ã With flame start
system
, p. 4 - 16.
Without flame
start system
This section pertains to starting a warm and cold engine.
• Do not press the accelerator.
• Turn the ignition key to position 3 and hold it there until the engine starts.
• Let go of the ignition key after the engine starts.
If the engine does not start, release the ignition key after approx. 15 seconds
and wait one minute before trying again.
H
If the engine does not start after multiple attempts; Ã Malfunctions on the
engine
, p. 7 - 27.
With flame start
system
The flame start system warms the suction air of the engine.
This section pertains to starting a warm and cold engine.
The flame start system is activated each time the ignition is turned on:
– When the engine is warm, the lamp (1) will light up only briefly
(2 to 3 seconds).
– When the engine is cold, the lamp (1) goes out as soon as the engine is
preheated (duration of up to 20 seconds).
Start the engine within the next 30 seconds; otherwise, you must switch
on the ignition again and wait until the lamp goes out.
S
Danger of explosion when using starter fuel!
The engine may never be started with the aid of starter fuel. The starter fuel
sprayed into the intake manifold can ignite.
S
Danger of explosion when using starter fuel
The engine may never be started with the aid of starter fuel. The starter fuel
sprayed into the intake manifold can ignite.
To Next Page
Loading...
Need help?
General
