Driving
5.6 Heating and air-conditioning system
Operating Manual GMK6300L 3 112 xxx en 5 - 85
xx.xx.xxxx
Switching the
automatic heat-
ing start on and off
To switch on an automatic heating start, you must retrieve the correspond-
ing storage location.
• To retrieve a storage location, press the button (1) once.
The display field flashes for 5 seconds and a storage location is shown
(e.g. 2). The heating start at this storage location is now switched on.
To switch on a different heating start, press the
u button repeatedly until
the desired storage location is displayed. This heating start is switched on
as soon as the display stops flashing.
To switch off the automatic heating start, press the
u button repeatedly
until no storage location is displayed any longer.
Setting the
remaining run
time
If the ignition is turned off while the auxiliary heater is running, the auxiliary
heater continues to run for the remaining time.
• Switch on the auxiliary heater using the button (1).
• Switch off the ignition.
The auxiliary heater continues to run and the residual run time set last
flashes, e.g. 48 minutes.
• Set the desired remaining time on the flashing display – button (1) or (2).
You can set a remaining time of 1 to 120 minutes.
• Wait for 5 seconds until the current time is displayed.
The remaining time is now set.
To Next Page
Loading...
Need help?
General
