Driving
5.6 Heating and air-conditioning system
5 - 84 3 112 xxx en Operating Manual GMK6300L
xx.xx.xxxx
Wait for approx. 5 seconds until the weekday for the heating start flashes,
e.g. MO for Monday.
• Set the weekday for the desired heating start – button (1) or (2).
Wait for approx. 5 seconds until the current time is displayed, e. g. 14.00.
Now, the new heating start has been saved and switched on.
H
If you wish to store one or two more heating starts, retrieve a new storage
location using the
u button and repeat the procedure.
After you have saved the heating start, you can also set the heating period;
à Setting the heating period, p. 5 - 84.
Setting the
heating period
After an automatic start, the auxiliary heater switches itself off as soon as
the set heating period has elapsed.
The heating period applies to all saved heating starts.
• Switch off the auxiliary heater using the button (1).
• Press the button (2) for longer than 3 seconds.
The last set heating period, e.g. 27 minutes, now flashes for 5 seconds in the
display field.
• Set the desired heating period on the flashing display – button (1) or (2).
You can set a heating period of 10 to 120 minutes.
Wait for approx. 5 seconds until the current time is displayed, e. g. 14.00.
A new heating period has now been set.
To Next Page
Loading...
Need help?
General
