OPERATING PROCEDURES GRT8120 OPERATOR MANUAL
4-68 Published 3-22-2021, Control # 702-02
increase the speed at which the numbers change. Once the
desired number or letter is shown, press the jog dial again to
confirm the selection.
The Tab Button (2, Figure 4-62) on the ODM and RDM
Navigation Control Pads can be pressed to temporarily
silence active audible alarms.
The Additional Information Button (6, Figure 4-62) on the
ODM Navigation Control Pad is used to get more information
about a crane control system (CCS) fault code.
USING THE OPERATOR DISPLAY MODULE
(ODM)
NOTE: Refer to Operator Display Module (ODM), page
3-18 for additional information.
The Operator Display Module (ODM) has two primary
screens:
1. Main Screen
For detailed information on the Main Screen of the ODM,
refer to the section titled Main Screen, page 4-69.
2. Menu Screen
For detailed information on the Menu Screen of the ODM,
refer to the section titled Menu Screen, page 4-90.
FIGURE 4-65
10254-3
10254-4
To Next Page
Loading...
Need help?
General
