MI 2893 / MI 2892 / MI 2885 E-Meter recorder (MI 2892/MI 2885)
102
Note: Recorder will run until one of the following end conditions is
met:
STOP key was pressed by user
Given Duration criteria was met
SD CARD is full
Note: If during record session instrument batteries are drained, due
to long interruption for example, instrument will shut down
automatically. After power restauration, it will automatically start
new recording session.
The n-th measurement is performed out of the total defined number
of measurements
Example: 3/5 the third measurement is active from the total
number of 5.
Energy (kWh/kvarh) registered by the Power Quality Instrument
Number of accepted pulses from the E-Meter from the total defined
number of pulses.
Example: 3/5 3 pulses accepted from the total selected number
of 5.
E-Meter error, getting from the individual measurement. On the LCD
screen only last 5 error results are presented. For the detailed view,
download data with PowerView and analyse the data.
Average error calculated from the individual measurements.
Table 82: Functional Keys in E-Meter recorder setup screen
Starts the recorder (selection, when recorder is not running)
Stops the recorder (selection, when recorder is running)
Reset E-Meter measurements results
(selection, when recorder is not running)
Shortcut to the PQI Connection setup.
(Selection, when recorder is not running)
E-Meter recorder setup.
(Selection, when recorder is not running)
Moves cursor to the next row up/down; enter desired
character
Field selection/Increase (Decrease) the value
To Next Page
Loading...
Need help?
General
